There are two other ways to make a possible Elf on the Shelf. More Ways to Make Elf on the Shelf Bendable Next, slide a new wire into the toe seam to the knee. This one will only be around an inch and a half as you are only going the length of the quad. Go behind the Elf’s bottom, slide in a new wire. Keep in mind, most of the Elf on the Shelf dolls have a seam at the knee so you will need to place a lower and upper craft wire (calf and quad) in each leg. Like I said, I folded my wire to thicken it and make Elf have a stronger bend. Lift up the arm pit and slide about three inches of wire into the elf’s arm. My craft wire was thin, so I doubled up by folding it in half before threading it under the armpits. The thicker the better but make sure it is able to be threaded through the seams of your Elf. If you don’t have it, hurry up and order it or run to your local craft store. I can wait to help you get your special elf to bend, hang, hug, groove, jig and more! Instructions:īefore you begin the steps for How to Make Elf on the Shelf Bendable, you need Craft Wire.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |